How to use SKP1000 to Program Freelander 2 Smart Card

字体 -

SKP1000 key programmer is able to program more than 3 smart cards to Land rover Freelander 2 pre-2012 via OBD. Here is the little guide on this. Check below. 
freelander-2
Select Freelander 2 (-2012)
(SKP1000 is also able to program smart card for Discovery 4 (-2012), Range Rover (-2012) and Evoque (-2012) )
select-freelander-2
Select Immobilizer system
select-immo
Select Old smart card programming

SKP-1000 can also program new smart card, read VIN, read key number and erase fault code for Land rover.
program-old-smart-card
Require at least 1 registered smart card,
click YES to continue
at-least-1-smart-card
Insert registered smart card
insert-registered-smart-card
Turn ignition switch to ON position 
turgn-ignition-on
Configuring
Wait about 1 minute
key-number-1
Current key number: 1
turn-ignition-off
Turn ignition to OFF position 
remove-smart-card

Remove smart card
insert-smart-card-again
Insert smart card again 
continue-to-program-next-key
Continue to program next key?
Click Yes to continue
remove-smart-card
Remove smart card
insert-next-smart-card
Insert next smart card, if bounce up, insert again
stuck-key-into-slot
Stuck the smart card into the key slot firmly
program-next-key
Continue to program next key?
Press Yes to continue, NO to go back
turn-ignition-on
Turn ignition ON
program-success
Program success.
Done.!

分享博文至:

    目前没有评论

发表评论