如何连接道通MK908 Pro 诊断工具到汽车上?

字体 -

Here Wallpaper UOBD2 Show you How to Build at The Connection Procedures ON the BETWEEN Autel MK908P Pro and by J2534 Vehicle Adapter.

1.Connect at The Cable’s main FEMALE Adapter Connector to the Data ON at The Vehicle Unit at The VCI, and at The Captive Screws Tighten.
A.for BT Wireless Diagnostic Interface

B.for J2534 ECU Programming Device

2.Connect the cable’s 16 pin male adapter to the vehicle’s DLC, which is generally located under the vehicle dash.

3.Power up the MaxiCOM display tablet, make sure the tablet has a charged battery or is connected to the PC power supply.

4.Pairing the display tablet with the VCI device via wireless BT to establish a communication link.

Note: at The Maxicom MK908P Run the display the Table and VCI Device IS the Configured to Automatically the Synchronize with the each OTHER First the when you use IT, SO there IS NO need to the perform the any Pairing Procedure.

5.When at The VCI Device at The IS Properly Connected to Vehicle and at The Maxicom display tablet, the VCI status button at the bottom bar on the display screen shows a green tick at the corner, indicating the platform is ready to start vehicle diagnosis.

The About Autel MK908 PRO More, Please the Check here Wallpaper:
http://www.uobdii.com/wholesale/autel-maxicom-mk908.html 

Article This article was from: How to Connect to Autel MK908P by J2534 Vehicle Device

分享博文至:

    目前没有评论

发表评论